Okay, here's my take on sharing my DIY pressure wand project, just like a seasoned blogger would:

## My DIY Pressure Wand for Hose – A Practical Project Log

Alright folks, so I was messing around in the garage the other day, trying to figure out a better way to wash my car. You know how it is – the regular hose nozzle just doesn't cut it for getting the grime off properly. I needed something with a little more oomph, a proper pressure wand. But those things can be kinda pricey, and I'm always up for a challenge. So, I decided to build my own!

First things first, I scrounged around for some materials. I had an old piece of PVC pipe lying around, about a foot long. Perfect! Then I dug out a brass hose connector from my toolbox. That's gonna be the base where the hose attaches. And lastly, I needed a nozzle – I found a high-pressure nozzle head from an old garden sprayer that was busted. Score!

• PVC pipe (about 1 foot long)
• Brass hose connector (male)
• High-pressure nozzle head
• PVC cement
• Teflon tape

Okay, so the first step was getting the hose connector attached to the PVC pipe. I wrapped some Teflon tape around the threads of the connector – gotta make sure it's nice and sealed. Then, I applied PVC cement to both the inside of the pipe and the outside of the connector. Shoved them together real good, and held it for a minute or two until it set.

Next up, the nozzle. This was a little trickier. The nozzle from the sprayer wasn't exactly designed to fit onto PVC. So, I grabbed my trusty Dremel tool and carefully widened the opening on the other end of the PVC pipe. Took my time with this, didn't want to crack the pipe. After a bit of fiddling, the nozzle finally fit snugly. Again, I used some PVC cement to secure it in place.

Now, for the moment of truth! I let the cement dry completely (gave it a good couple of hours). Then, I connected my garden hose to the brass fitting. Turned on the water…and…success! The water shot out of the nozzle with way more pressure than a regular nozzle. I adjusted the nozzle head to get the spray pattern I wanted. It actually worked!

Of course, it wasn't perfect. The PVC pipe is a little short, so I might swap it out for a longer piece later. And I might look for a more heavy-duty nozzle. But for now, it's a huge improvement! I used it to wash my car, and it blasted away all the dirt and grime with ease. Definitely worth the effort.

So there you have it – my DIY pressure wand for a hose. It's not pretty, but it works! If you're looking for a cheap and easy way to get more pressure from your hose, give it a try. Just be careful when working with PVC cement and power tools. And remember, safety first!

Next up I might try and make a foam cannon, that sounds like a fun project!