Alright, so today I'm gonna walk you through my little power washer scrubber project. It's not rocket science, but it definitely made cleaning my patio a whole lot easier.

First off, I grabbed my power washer. Nothing fancy, just a standard one I picked up a while back. It's got a decent PSI, which is key for this project.

Then, I started scavenging around the garage. I was looking for something I could adapt into a scrubber head. Found an old, round scrubbing brush attachment from a floor cleaner that was just gathering dust, perfect!

Next up was the tricky part: figuring out how to attach it. I eyed up the power washer wand and the brush attachment. I needed a connector that would let the water flow through and hold the brush securely. I rummaged through my plumbing bits and bobs and found a couple of PVC fittings that looked promising.

Time to get messy! I used a heat gun to soften the PVC slightly, then carefully shoved the brush handle into one of the fittings. It was a tight fit, which is exactly what I wanted. Then, I used some heavy-duty epoxy to glue everything together. I let that cure overnight.

The next day, the epoxy was rock solid. I attached the other end of the PVC fitting to the power washer wand using another fitting and some Teflon tape to ensure a watertight seal. I made sure everything was tightened up properly.

Now for the moment of truth: the test run! I hooked up the power washer to the water supply, switched it on, and aimed it at a dirty patch of concrete on my patio. Pulled the trigger… and bingo! The water shot through, the brush started spinning, and the grime started disappearing.

Of course, it wasn't perfect on the first go. The brush head was a bit wobbly, so I added some extra supports with zip ties to stabilize it. That did the trick.

I spent the next couple of hours scrubbing the entire patio. It was so much faster and easier than using just the power washer nozzle alone. The brush really helped to loosen the stubborn dirt and algae.

Here's the lowdown:

• Find a suitable scrubbing brush attachment.
• Figure out the connection method – PVC fittings and epoxy are your friends.
• Make sure everything is secure and watertight.
• Test and tweak as needed. Zip ties can be surprisingly useful!

Overall, this power washer scrubber mod was a huge success. My patio looks brand new, and I saved myself a ton of elbow grease. Plus, it was a fun little DIY project. Give it a try if you're looking for an easier way to clean your outdoor spaces!