Is your AC showing high suction pressure hvac? Heres what you need to check immediately.
2025-06-14Source:Hubei Falcon Intelligent Technology
Okay, here's my take on sharing my experience with a "high suction pressure HVAC" situation, mimicking the requested style:
Alright folks, lemme tell ya about this HVAC headache I ran into last week. High suction pressure... sounds fancy, but basically, the AC wasn't cooling right. I mean, it was blowing air, but felt like a hair dryer, not the arctic blast I was hoping for in this summer heat.
So, first thing I did? Grabbed my gauges. Yeah, I got a set. Figure if you own a house, you gotta learn some basic stuff, right? Hooked 'em up to the service ports. Lo and behold, suction pressure was way high – like, pegged outta the normal range high. My brain started churning. What the heck is going on?
Next up, I did the obvious. Filter check! Clogged filters can do all sorts of crazy things. Pulled it out, and BAM! Looked like someone had stuffed a shag carpet in there. Replaced it with a fresh one, nice and clean. Fired up the AC... Nope. Still high suction. Dammit!
Okay, think, think! What else could cause this? My buddy, who knows a bit more about this stuff than I do, suggested I check the evaporator coil. Said it might be iced up. So, I killed the power to the unit (safety first, people!), pulled off the access panel, and shined a flashlight in there. Sure enough, a big ol' block of ice. Not good.
Now, an iced-up coil usually means low airflow or low refrigerant. I already checked the airflow with the new filter, so I started suspecting a refrigerant issue. I let the ice melt completely by turning off the ac for a while. It took a long time but hey it was a good time to watch some shows.
This is where things got a little tricky. I wasn't about to start messing with refrigerant without knowing what I was doing. So I called a HVAC tech and he took a look and realized it was low refrigerant. He used his special tools to check for leaks, found a small one, fixed it, and then added the correct amount of refrigerant.
After he left, I hooked my gauges back up. Suction pressure was right where it should be! Fired up the AC, and finally got that sweet, sweet cold air. Victory! Well, kinda. I still had to pay the HVAC guy. But hey, at least I learned something, right?
- Checked the Gauges: First and foremost, gotta know what's going on with the pressure.
- Replaced the Filter: Always start with the easy stuff.
- Checked the Evaporator Coil: Looked for ice buildup.
Lessons Learned
HVAC can be a pain. Don't be afraid to call a pro when things get complicated. Sometimes it's better to pay someone than to risk messing things up worse. Also, keep those filters clean! It can save you a lot of headaches.